WhiteTiger Blogs

Cisco Unified Operations Manager 2.2 may produce an error about the server locale during the install.

And even though you checked the Regional Setting in Control Panel etc, you still get the error. Then its time to dive into the registry.

You need to edit your registry and remember to reboot.
Registry must be:
HKEY_USERS\.DEFAULT\Control Panel\International\Locale = 00000409
HKEY_CURRENT_USER\Control Panel\International\Locale = 00000409

cheers

(3 votes, average: 4.33 out of 5)

 Loading ...

I’ve seen this problem couple of times and thought its worth publishing.  Sometime the ACS SE loses its IP address when trying to set it up and reverts to DHCP.

Well, you really only need to apply this simple rule:  Plug a network cable in the ACS SE and just for kicks, ping the gateway.

Even though it has been said that this was fixed with patch: applACS-4.1-set-ip-CSCsm73656-Patch.zip, I still found this behaviour with ACS 4.2.

And oh yes, Its not a router console – so set-up your terminal software for console access like this:

•Baud = 115200
•Databits = 8
•Parity = N
•Stops = 1
•Flow control = None

Cheers

(1 votes, average: 4.00 out of 5)

 Loading ...

QPM still underdeveloped.

Is it just me or does QPM seem to be still in preschool?  With Release 4.1 there are two patches released after. But still, it would seem as though device support is a mystery.

Suppose you need to configure QOS on 4503-SUP6 on the supervisor module. Sure, only if you’re running IOS 12.1E.  And if you need auto-qos it needs to be 12.2S.  And then there’s the  strange missing information about the 4503 line cards. Still investigating.